Categories: Sensors
5 mm LDR Sensor
Rated 0 out of 5
0 ReviewsLDR 5 mm Photo Resistor
LDR 5 mm Photo Resistor
DHT 22 Temperature and Humidity Sensor
Rated 0 out of 5
0 Reviews
DHT 22 Temperature and Humidity Sensor
DHT 22 Temperature and Humidity Sensor
DHT11 Humidity / Temperature Sensor Module
Rated 0 out of 5
0 Reviews- Reports humidity over range of 20% to 90%
- Reports temperature over range of 0°C to 50°C
- Uses 1-Wire interface
- 3.3 and 5V logic compatible
- Reports humidity over range of 20% to 90%
- Reports temperature over range of 0°C to 50°C
- Uses 1-Wire interface
- 3.3 and 5V logic compatible
Categories: Sensors
DS18B20 Temperature Sensor Module
Rated 0 out of 5
0 Reviews- -55°C to +85°C temperature measurement range with good accuracy
- 1-wire interface to save on MCU pins
- LED to indicate module communications
- 3.3 and 5V compatible
- -55°C to +85°C temperature measurement range with good accuracy
- 1-wire interface to save on MCU pins
- LED to indicate module communications
- 3.3 and 5V compatible
Categories: Sensors
DS18B20 Waterproof Temperature Sensor
Rated 0 out of 5
0 Reviews
Stainless Steel SheathSize: 6 x 50mm; 36 inch long wire with 4.7 K ohm ResistorPower Supply Range: 3.0V to 5.5VOperating Temperature: -55c to 125cStorage Temperature: -55c to 125cAccuracy throughout range: -10c to 85c: +/- 0.5cOutput Leads: Red (VCC), Blue (Data), Black (GND)
Stainless Steel SheathSize: 6 x 50mm; 36 inch long wire with 4.7 K ohm ResistorPower Supply Range: 3.0V to 5.5VOperating Temperature: -55c to 125cStorage Temperature: -55c to 125cAccuracy throughout range: -10c to 85c: +/- 0.5cOutput Leads: Red (VCC), Blue (Data), Black (GND)
Categories: Sensors
Finger Print Sensor Module
Rated 0 out of 5
0 Reviews
Model- R307
Model- R307
Categories: Sensors
Flame Sensor
Rated 0 out of 5
0 Reviews- Pin1 (VCC pin): Voltage supply rages from 3.3V to 5.3V
- Pin2 (GND): This is a ground pin
- Pin3 (AOUT): This is an analog output pin (MCU.IO)
- Pin4 (DOUT): This is a digital output pin (MCU.IO)
- Pin1 (VCC pin): Voltage supply rages from 3.3V to 5.3V
- Pin2 (GND): This is a ground pin
- Pin3 (AOUT): This is an analog output pin (MCU.IO)
- Pin4 (DOUT): This is a digital output pin (MCU.IO)
Categories: Sensors
IR Sensor
Rated 0 out of 5
0 Reviews- Detection range: 2cm to 30cm
- Detection angle: 35 degrees
- Operating voltage: DC 3.3V to 5V
- Output signal: TTL level
- Detection range: 2cm to 30cm
- Detection angle: 35 degrees
- Operating voltage: DC 3.3V to 5V
- Output signal: TTL level
Categories: Sensors
LDR Module
Rated 0 out of 5
0 Reviews
Specification:
- Input Voltage: DC 3.3V to 5V
- Output: Analog and Digital
- Sensitivity adjustable
Specification:
- Input Voltage: DC 3.3V to 5V
- Output: Analog and Digital
- Sensitivity adjustable
Categories: Sensors
Max30100
Rated 0 out of 5
0 Reviews
1. Consumes very low power (operates from 1.8V and 3.3V)
2. Ultra-Low Shutdown Current (0.7µA, typ)
3. Fast Data Output Capability
4. Interface Type: I2C
1. Consumes very low power (operates from 1.8V and 3.3V)
2. Ultra-Low Shutdown Current (0.7µA, typ)
3. Fast Data Output Capability
4. Interface Type: I2C
Categories: Sensors
MQ-4 Methane Natural Gas Sensor
Rated 0 out of 5
0 ReviewsFeatures :
- Signal output indicator
- Dual Signals output (analog output and TTL output)
- The TTL output signal is low level, allows to connect with SCM directly
- Analog output 0~5V voltage
- High sensitivity
- Long working life and stable performance
- Quick response and recovery.
Features :
- Signal output indicator
- Dual Signals output (analog output and TTL output)
- The TTL output signal is low level, allows to connect with SCM directly
- Analog output 0~5V voltage
- High sensitivity
- Long working life and stable performance
- Quick response and recovery.
Categories: Sensors
Rain Sensor Module
Rated 0 out of 5
0 Reviews- Adopts high quality of RF-04 double sided material.
- Area:5cm x4cm nickel plateon side
- Anti-oxidation,anti-conductivity, with long use time
- Comparator output signal clean waveform is good, driving ability, over 15mA
- Potentiometer adjust the sensitivity
- Working voltage 5V
- Output format: Digital switching output (0 and 1) and analog voltage output AO
- With bolt holes for easy installation
- Small board PCB size: 3.2cm x 1.4cm
- Uses a wide voltage LM393 comparator
- Adopts high quality of RF-04 double sided material.
- Area:5cm x4cm nickel plateon side
- Anti-oxidation,anti-conductivity, with long use time
- Comparator output signal clean waveform is good, driving ability, over 15mA
- Potentiometer adjust the sensitivity
- Working voltage 5V
- Output format: Digital switching output (0 and 1) and analog voltage output AO
- With bolt holes for easy installation
- Small board PCB size: 3.2cm x 1.4cm
- Uses a wide voltage LM393 comparator
Categories: Sensors
Soil Moisture Sensor
Rated 0 out of 5
0 Reviews
Operating voltage: 3.3V~5V.
Adjustable sensitivity (shown in blue digital potentiometer adjustment)
Dual output mode,analog output more accurate.
A fixed bolt hole for easy installation.
With power indicator (red) and digital switching output indicator (green).
Having LM393 comparator chip, stable.
Operating voltage: 3.3V~5V.
Adjustable sensitivity (shown in blue digital potentiometer adjustment)
Dual output mode,analog output more accurate.
A fixed bolt hole for easy installation.
With power indicator (red) and digital switching output indicator (green).
Having LM393 comparator chip, stable.
Categories: Sensors
Thermistor Temperature Sensor Module
Rated 0 out of 5
0 Reviews- Uses NTC thermistor
- Measurement range of -55 to +125°C
- Provides analog output of the reading
- 3.3 and 5V operation
- Uses NTC thermistor
- Measurement range of -55 to +125°C
- Provides analog output of the reading
- 3.3 and 5V operation
Categories: Sensors
Ultrasonic Sonar Sensor
Rated 1.00 out of 5
(1.00)1 Review
(1) Using IO trigger for at least 10us high level signal,
(2) The Module automatically sends eight 40 kHz and detect whether there is a
pulse signal back.
(3) IF the signal back, through high level , time of high output IO duration is
the time from sending ultrasonic to returning.
Test distance = (high level time×velocity of sound (340M/S) / 2
(1) Using IO trigger for at least 10us high level signal,
(2) The Module automatically sends eight 40 kHz and detect whether there is a
pulse signal back.
(3) IF the signal back, through high level , time of high output IO duration is
the time from sending ultrasonic to returning.
Test distance = (high level time×velocity of sound (340M/S) / 2
Categories: Sensors
Water Level Sensor
Rated 0 out of 5
0 Reviews
Water Level Sensor Depth of Detection Sensor for ArduinoOperating voltage: DC3-5V
Operating current: less than 20mA
Sensor Type: Analog
Detection Area: 40mmx16mm
Operating temperature: 10℃-30℃
Humidity: 10% -90% non-condensing
Water Level Sensor Depth of Detection Sensor for ArduinoOperating voltage: DC3-5V
Operating current: less than 20mA
Sensor Type: Analog
Detection Area: 40mmx16mm
Operating temperature: 10℃-30℃
Humidity: 10% -90% non-condensing